Enterasys Matrix E6 5G102-06-G, Руководство пользователя

Страница: 158 / 196

Setting Password Protection
11-2 Configuring and Monitoring the Switch
•
Configuring IGMP multicast filtering ( Section 11.13 )
•
Configuring port operation (enable/disable, port speed, full/half duplex, flow control, and
broadcast threshold) (
Section 11.14 )
•
Configuring the Unicast Address table ( Section 11.15 )
•
Setting a Default Gateway ( Section 11.16 )
•
Configuring SmartTrunks ( Section 11.17 )
•
Configuring 802.1X and EAP security and authentication ( Section 11.18 )
•
Setting the limit on received broadcast frames ( Section 11.19 )
11.2 SETTING PASSWORD PROTECTION
The switch is factory-configured with administrator access rights to the console menus set to
READ/WRITE. This setting allows anyone to use the console menus to modify any operational
parameter. To protect the configuration of the switch from unauthorized modification, you should
enable password protection to the console menus.
To enter a password, proceed as follows:
1. Select Management Setup Menu from the Main Menu and press ENTER.
2. Select Console Login Configuration and press ENTER.
3. For the “ADMIN” user type, enter a password containing up to 11 alphanumeric characters.
Note that the password is not case sensitive.
By factory default, there is no password configured. This means that at the login: prompt, all you
have to do is type “admin” for the username and press ENTER to gain READ/ WRITE access to
the console menus. When you configure the password parameter, the factory default setting is
deactivated and the new password governs access to the console menus.
If you forget your password, contact your Enterasys Networks Support Representative.
NOTE: You are automatically logged out from the console menus based on the
Lock-out Time setting in the Console Login Configuration Menu. A setting of “0” permits
the console menus to remain available indefinitely.