Enterasys G3G170-24, Справочное руководство CLI

Страница: 610 / 679

set radius accounting
20-8 Security Configuration
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured.
For details on enabling and configuring RADIUS accounting, refer to “ set radius accounting ” on
page 20 ‐ 8:
G3(ro)->show radius accounting
RADIUS accounting status: Disabled
RADIUS Acct Server IP Address Acct-Port Retries Timeout Status
------------------ ---------- --------- ------- ------- ------
1 172.16.2.10 1856 3 20 Disabled
set radius accounting
Use this command to configure RADIUS accounting.
Syntax
set radius accounting {[ enable | disable ] [ retries retries ] [ timeout timeout ]
[ server ip_address port [ server-secret ]
Parameters
Mode
Switch command, read ‐ write.
Defaults
None.
enable | disable Enables or disables the RADIUS accounting client.
retries retries Sets the maximum number of attempts to contact a specified RADIUS
accounting server before timing out. Valid retry values are 0 ‐ 10 .
timeout timeout Sets the maximum amount of time (in seconds) to establish contact with a
specified RADIUS accounting server before timing out. Valid timeout
values are 1 ‐ 30 .
server ip_address
port server ‐ secret
Specifies the accounting server’s:
• IP address
• UDP authentication port ( 0 ‐ 65535)
• server ‐ secret (Read ‐ Write password to access this accounting server.
Device will prompt for this entry upon creating a server instance, as
shown in the example below.)