Enterasys G3G170-24, Справочное руководство CLI

Страница: 467 / 679

redistribute
Enterasys G-Series CLI Reference 16-9
Mode
Router configuration: G3 ( su) ‐ >router(Config ‐ router)#
Usage
This command does not affect the sending of RIP updates on the specified interface.
Example
This example shows how to deny the reception of RIP updates on VLAN 2:
G3(su)->router(Config)#router rip
G3(su)->router(Config-router)#no receive-interface vlan 2
redistribute
Use this command to allow routing information discovered through non ‐ RIP protocols to be
distributed in RIP update messages. The no form of this command clears redistribution
parameters.
Syntax
redistribute { connected | ospf process-id | static } [ metric metric value ]
[ subnets ]
no redistribute { connected | ospf process-id | static }
Parameters
Mode
Router configuration: G3(su) ‐ >router(Config ‐ router)#
Defaults
If metric value is not specified, 1 will be applied.
If subnets is not specified, only non ‐ subnetted routes will be redistributed.
connected Specifies that non ‐ RIP routing information discovered via directly
connected interfaces will be redistributed.
ospf Specifies that OSPF routing information will be redistributed in RIP.
process ‐ id Specifies the process ID, an internally used identification number for each
instance of the OSPF routing process run on a router. Valid values are 1 to
65535 .
static Specifies that non ‐ RIP routing information discovered via static routes will
be redistributed. Static routes are those created using the ip route
command detailed in “ ip route ” on page 15 ‐ 19.
metric metric value (Optional) Specifies a metric for the connected, OSPF or static
redistribution route. This value should be consistent with the designation
protocol.
subnets (Optional) Specifies that connected, OSPF or static routes that are
subnetted will be redistributed.