ENSONIQ SPM-1, Руководство музыканта

Страница: 9 / 24

SPM-1 Musician’s Manual ENSONIQ Corporation
Page 5
When you power up the SPM-1, you’ll get a little light show on the control panel. The LED’s on the Bank and Sound
buttons will briefly light in a sequence. The SPM-1 is checking itself to make sure all the voices are working and the
filters and levels are set properly. This initial start takes about 2 seconds. The SPM-1 will always power up with the
Piano 1 sound selected. When the sequence of flashing LED’s stops, you should see the Bank A and Piano 1 LED’s
lit. Simply adjust the volume control to the desired level and play.
If you are using the sound system with a lot of tone control (equalization) potential, it’s best to start with
everything in the ‘0’ or flat response position and make adjustments from there. Since the piano sound is by nature
quite complex, the best sound will be achieved by using high fidelity components.
The sound of the SPM-1 is very rich in harmonics, so even the low notes will have a considerable amount of high
frequency content. When making equalization changes, check the sound across the entire keyboard from time to
time for overall balance. In most cases, a little equalization will work better than a lot.