Page 12
SOLAR AQUAAIR ULTRA
INSTALLATION INSTRUCTIONS (cont.)
6. (For Solar AAU1 only) Connect the solar panel positive (+) lead to
the inline fuse included with your unit. Connect the solar panels to
the compressor enclosure using the male and female MC4
connectors preinstalled on your solar panel and compressor
enclosure.
7. (For Solar AAU2 only) Connect the 2 solar panel positive (+) leads
to the included wye connector with an inline fuse. Connect the 2 solar
panel negative (-) leads to the remaining wye connector. Connect the
wye connectors to the compressor enclosure using the male
and female MC4 connectors preinstalled on your solar panel(s) and
compressor enclosure.
8. Make sure the disconnect switch for the batteries is switched in the off
position.
CAUTION: Read and follow all safety information below before
connecting batteries.
• Wear eye protection when working with batteries. Have water
available to wash and clean any contact with battery acid.
• Charge only lead-acid batteries that are properly sized for the system.
• Explosive battery gasses can be present during charging. Make sure
there is proper ventilation to release any battery gasses.
• Only use insulated tools near batteries. Avoid metal objects near
batteries.
9.
(SAAU1)
Place batteries into the compressor enclosure in between
the eyebolts as shown in the diagram below and on the inside of the
compressor enclosure cover. Place the included j hook bolts through
the eye bolts. Place the compressor hold down bar over the batteries
and through the j hooks. Fasten the bar using the supplied wing nuts.
(SAAU2)
Thread the included threaded rod into each of the threaded
inserts in the base of the compressor enclosure. Place batteries into
the compressor enclosure in between the threaded rod as shown in
the diagram below and on the inside of the compressor enclosure
cover. Place the compressor hold down bars over the batteries and
through the threaded rod. Fasten the bar using the supplied wing
nuts.
