3 - 1
Replacement of
SmartFlo™ SF-1 Water Cartridge
For the best tasting and highest quality water, it is recommended to change the SmartFlo™ SF-1 Water
Cartridge every 12 months. Follow the steps below to replace the SmartFlo™ SF-1 Water Cartridge. It is
recommended to empty the bottle prior to replacement of the SmartFlo™ SF-1 Water Cartridge.
Note: A flashing blue light above the cold water lever will alert you to when the SmartFlo™ SF-1 Water
Cartridge should be replaced. The system has been pre-set to provide indication after a period of 12
months of use. User may operate the cooler as normal until the bottle has been emptied.
Note: To reset the life timer system, the SmartFlo™ SF-1 is required to be removed from the dispenser
for a minimum of 15 seconds while the unit is connected to the mains power supply.
1. Slide the access door upwards to open (Figure 3-1).
2. Slide POU system out of cabinet (Figure 3-2 and Figure 3-3).
3. Disconnect the water line from the POU system (Figure 3-4).
4. Open the replacement SmartFlo™ SF-1 Water Cartridge kit, and remove the access key provided.
Notice:
The information and/or procedures presented in the following demonstration(s) should be performed by a trained Water
Cooler Service Technician only.
Prior to any service or repair of the water cooler, ensure that the water has been completely drained from the system.
Figure 3-1
Figure 3-4
Figure 3-2 Figure 3-3
