background image

[email protected]  I  www.autopot.co.uk  I  +44 (0)844 8581520

[email protected]  I  www.autopot.co.uk  I  +44 (0)844 8581520

Your 80Pot system 

set-up guidelines

Ensuring that the AQUAvalve floods 
and drains correctly

Care and maintenance

Making sure your AQUAvalve floods and 

drains correctly is simply achieved and 

only takes a few seconds. 

Hold the AQUAvalve at eye level so that 

you can see the silicon fitted to the top float 

resting on the hole below it.

The silicon must create a tight seal when 

touching the hole. 

If it looks like it is not sitting parallel on the 

hole below, simply lift the top float and 

apply pressure to one side of the silicon, 

drop the float and hold at eye level again. 

Repeat the procedure if necessary.

At the end of your growing season, clean 

the AQUAvalve using warm soapy water. 

Using an old tooth brush will help.

The AQUAvalve is easily disassembled. 

The top float will slide all the way across 

and the bottom float is unclipped from its 

pivoting position. The circular discs fitted to 

the top float can also be removed by using 

pliers to grip the raised point.

At this point is it advisable to remove the  

silicones to avoid them being lost.

It is also handy to have a paper clip or 

pipe cleaner to hand so that you can push 

it through the AQUAvalve nozzle, this will 

remove any lime scale build up that may 

have occurred during the growing season.

Blowing through the AQUAvalve nozzle will 

also help to remove any build up. Do not 

under any circumstances use a drill & drill 

bit to clear the AQUAvalve nozzle.

This will potentially damage the 
AQUAvalve beyond repair.

Simple care

guidelines

1

1

2

2

3

4

Ensure the silicon is sitting parallel on 

the hole below it. Hold at eye level 

to check the position is correct

plants

Allow your

to 

establish

 

before tur

ning your

 

system 

on

.

80

Reviews: