Repeater-EnO868SELV
EnOcean Repeater 868 MHz
Repeater-EnO868USB
Read the operating instructions carefully before commissioning.
Installation and operating instructions
Rev.: February 2016
Repeater-EnO868_104126_OperationManual_E_FEB2016.doc/pdf
Page 3 of 7
BootUp GmbH
|
Sonnenbergstrasse 23
|
CH-5236 Remigen
|
Switzerland
|
Phone +41 56 284 09 21
|
Fax +41 56 284 09 22
2016
|
Omi technical changes excepted
|
www.BootUp.ch
|
www.myHomeControl.ch
|
Repeaters should be placed centrally.
Source: EnOcean GmbH
Note:
Using bi-directional communication and signal routing via two repeaters, both must be in the operating
mode
Level 1+2
.
Operating status display and mode of operation settings via switches
Lower side of the device: LEDs show the operating state. Switch is used for settings.
Operating status display:
green LED <Power> is on, when device is powered.
yellow LED <Radio> flashes for each received radio signal, even if the
signal is not amplified.
Settings via switch
Repeater Function: Deactivate / Activate
In position
Rep. OFF
is the Repeater function switched off, only the post-
master is activ.
In position
Rep. ON
is the Repeater function switched on.
Repeater Function Mode: Level 1 / Level 1+2
Only active, when
Rep. ON
In position
Level 1
is the Repeater function Level 1 active.
In position
Level 1+2
is the Repeater function 2 active.
Upper side of the device:
Operating status display:
red LED in the housing cover (middle circle) <Locate>, lights up as soon
as the remote management request "locate" has been received.
Transmitter
or
Receiver
