Enlogic EN1201, Инструкция по установке и эксплуатации, Страница: 20 / 56

www.enlogic.com 20
To require users to access the Web UI via HTTPS
1. Go to Device Configuration > Security > Force HTTPS for Web Access.
2. When this option is selected, a confimation dialog box will appear to apply the HTTPS settings.
3. Select Yes to confirm. This will reset the Network Card.
SNMP
Enabling SNMP communication allows the Enlogic Energy Series PDU to send events from an SNMP trap to you
and allows you to view and control the status of outlets. Refer to Section 4: SNMP for instructions on the use of
SNMP with the Enlogic Series PDU.
SSH
Enabling SSH allows for a user to login to the CLI using an SSH client (such as PuTTY) or change the TCP port for
the SSH service.
Notes:
• SSH and HTTPS are enabled at the same time but users CANNOT login in through HTTPS and SSH
simultaneously.
• It is not allowed two users to login in SSH/Telnet at the same time.
• Serial connection priority is higher than Telnet and SSH connection, Telnet and SSH is not available while
Serial connection is enabled.
Telnet
Enabling Telnet allows for a user to login to the CLI using a Telnet client (such as PuTTY) or change the TCP port
for the Telnet service.
FTP
Only Admin users can access FTP settings.
Network Configuration
To modify Internet Protocol (IPv4 or IPv6*) and Settings,
1. Go to Device Configuration > Network Configuration.
2. Select the desired options on the IP Protocol Tab.
3. If using IPv4, open the IPv4 tab and select either Static to manually assign the PDU IP address, or DHCP to set the
PDU Ip address to be auto-configured.
• Select Static to manually enter an IP address. Enter the following information: IP address, Net Mask,
Gateway, Primary DNS server, Secondary DNS server, DNS Suffix (
optional
)
• Select DHCP if you wish to auto-configure the PDU IP address. Select the “Specify DNS server
manually” checkbox if necessary. Then type the address of the primary DNS server and secondary
DNS server.
*IPv6 will be available with an upcoming firmware upgrade.
Security
Login Settings
User Blocking will lock you out of the system after a specified number of failed login attempts. To setup User
Blocking:
1. Go to Device Configurations > Security > Login Settings