Eng3 4650-00, Руководство пользователя, Страница: 21 / 44

eng
3
15
8
Operating in SmartCard Mode
SmartCard mode is available in the NanoVi Exo
™ and NanoVi Pro™ devices, not the Eco device.
Skip to section 9 if you have a NanoVi
Eco™ device.
Insert SmartCards with the arrow showing on the top of the card pointing into the device. The metallic
chip must be facing down for the card to work.
Two types of SmartCard are used to operate the device. The Owner Card is used to put the device in
SmartCard mode, to program preferences, and to load User Cards with minutes. The User Card is
used to operate the device when it is in SmartCard mode. A 4-digit code is printed on the Owner and
User Cards that come with the device. This 4-digit code is unique and specific to the device it comes
with. The User Cards will only work with the device that was used to program them.
8.1
Owner Card
The owner card can be inserted any time when the device is turned on. It overrides the current
functions and presents the administrative screen shown in Figure 8.1. The Owner Card has three
basic functions: 1) set preferences on the device, 2) set the operation mode of the device, and 3)
program User Cards. Each of these functions is described below. The Owner Card administration
screen also shows the rent time (number of minutes of use) and allows you to reset the rent time by
pressing the circular arrow at the bottom of the screen.
Figure 8.1: Owner Card administrative screen
Timer mode
Infinity mode
Page up to operating mode
Set brightness
User card mode
Reset rent time
Rent time
Page down to program
User Cards
Set tone volume