Enfinity 1000TL, Руководство по установке

Страница: 14 / 40

14
6.2 Identification of the Enfinity inverter
You can identify the Enfinity inverter type by the product label found on the right-hand side of the housing.
6.3 Installation precautions
Check the environment where the system is installed
Check that the installation site does not have any of the following conditions:
• The ambient temperature is outside the range of tolerable ambient temperature
(-20°C to +60°C, -4°F to +140°F,).
• Higher than the altitude of about 2,000 m above sea level.
• Prone to be damaged by sea water.
• Close to corrosive gas or liquid (for example, locations where chemicals are processed).
• Exposed to direct sunlight.
• Prone to be flooded or high levels of snow pack.
• Little or no air flow and high humidity.
• Exposed to steam, vapor, or water.
• Exposed to direct cool air.
• Near the television antenna or antenna cable.
• Ventilation is insufficient to cool the inverter, that is to say, outdoors, the inverter requires at least 30
cm (see table and illustration) of clearance around the unit. It is recommended that the same clearance
between the unit and the ground be used. Installing the inverter with inadequate ventilation may cause
the system to malfunction as a result of water or excessive high temperature inside the inverter.
Please advise users that Enfinity will not compensate any fault caused in this way.
• Flammable underground.
• Don’t install on gyproc wall to avoid the noise or vibration.
Device type
Serial number
Figure 9: product label