PROFInet Module
SINUS H
15
/
34
5.3.3
[COM-10–21] IP Address, Subnet Mask, Gateway Settings
The Sinus H PROFInet communication module supports IPv4 protocol. All addresses and masks are
expressed with four decimal numbers between 0 and 255, each separated by a dot (xxx.xxx.xxx.xxx).
A PLC can forcibly reset the IP address by sending a DCP packet.
For example, when programming a PLC in Siemens TIA, you can select
Set IP address in the
project (
) to allow the PLC to send a DCP packet to a communication module to set an IP address.
If you select
IP address is set directly at the device
(
), the PLC reads the IP address set at the
communication module and uses it for PROFInet network communication, instead of resetting the IP.
5.3.4
[COM-22] Telegram Mode Settings
The Sinus H PROFInet Communication module supports two different types of telegrams. Refer to
