ENERGREEN RoboMAX, Инструкция по эксплуатации и обслуживанию, Страница: 63 / 105

55
© 2017 Energreen Srl
Professional machinery
6.9 - TROUBLESHOOTING
Given that most of the functioning defects occur because of the improper use of the machine, the
following table shows a number of possible malfunctions that could arise and steps to take to avoid them.
NOTE: in the case the anomaly or the cause that has caused it do not come under the defects indicated,
contact the ENERGREEN company.
6.9.1 - DIESEL ENGINE
Malfunctions Causes Measures
A symbol appears when the engine is running
Engine oil pressure symbol Engine oil level low Top up the oil to the required level
Engine oil level too high
Engine oil filter clogged Replace the engine oil filter
Engine coolant symbol Engine coolant level low Top up the engine coolant
Radiator fins dirty Clean the radiator fins
Engine coolant leakage Contact ENERGREEN customer care
Timing belt loose or damaged Adjust the tension of the belt or replace it
Engine coolant pump faulty Contact ENERGREEN customer care
Battery symbol Timing belt loose or damaged Adjust the tension of the belt or replace it
Battery low Check the battery
Alternator faulty Contact ENERGREEN customer care
The engine does not start when switched on, a symbol appears
Battery symbol Alternator faulty Contact ENERGREEN customer care
Engine oil pressure symbol Engine oil pressure switch faulty
Engine oil level low / no oil Top up the oil to the required level
Engine oil filter clogged Replace the engine oil filter
The engine does not start
The starter motor is working
but the engine does not
start
No fuel Refuel and prime the fuel system
Air in the fuel system Bleed the fuel system
Unsuitable type of diesel Replace with a suitable type of diesel
Fuel filter clogged Replace the fuel filter
Low fuel injection Contact ENERGREEN customer care
Compressed air leaking from the intake / discharge valves
Engine stop solenoid faulty
The starter motor does not
work or rotates too slowly
(the motor can be turned
by hand)
The battery needs to be recharged Check the electrolyte / recharge the battery
Bad cable connection to the battery terminals Clean the terminals, re-tighten
Start up relay faulty Contact ENERGREEN customer care
Starter motor faulty
The motor cannot be turned
by hand
Internal parts of the motor seized or damaged
White or black exhaust gases
If the fault or the reason for it is not indicated in the list of faults shown, contact ENERGREEN in order for repairs to be carried out.