ENERGREEN RoboMAX, Инструкция по эксплуатации и обслуживанию, Страница: 17 / 105

9
© 2017 Energreen Srl
Professional machinery
2.4 - IDENTIFICATION OF THE MACHINE
The machine's identification plate is fixed to the front left-hand side of the chassis.
ENERGREEN
2.5 - NOISE LEVEL
LpA = This value indicates the maximum sound level
perceived by the operator calculated by making a
worst case assessment at the 4 points around the
machine being tested.
L
wa
= This value indicates the sound level outside
the machine and refers to the noise perceived by
those who are in the vicinity of the work area.
Standards EN ISO 3744:2010, EN ISO 11201:2010
• Adhesive warning/information plates have been affixed to the machine, the purpose of
which is to make it safer to use. For this reason, they must be replaced if they are no
longer legible.
• The operator must not be someone who works occasionally on this machine. He must
have accumulated a certain experience with this type of machine, therefore skilled and
trained.
• Whenever direct visibility of the work zone from the control station is not sufficient,
the operator must be assisted by a specifically assigned person.
• Check the condition and operation of any part subject to wear daily: (pins, valves,
piping, etc.). When necessary, replace with original materials.
• Do not tamper with the hydraulic system for any reason, and in any case never remove
the seal from the valves, or any and all warranties shall lapse. Contact an authorised
repair shop if the valves should require adjustment.
• Excessive heating of the hydraulic fluid can damage the seals of the hydraulic circuit
and lead to the deterioration of the fluid itself. Heating is caused by the rolling oil by
means of the pressure relief valve. For this reason, avoid prolonged operation with the
jacks at the end of stroke.
WARNING:
99 106