Part 1 – Introduction
12
USB Port Connection
Connect a USB-to serial converter and connect multiple
text-in devices to the NVR at the same time.
For USB flash memory devices, the NVR supports
the FAT32 file format only.
eSATA Connection
Connect external hard drives to these ports.
Do not connect or disconnect an eSATA device while
the NVR is powered on. To connect an eSATA device,
first turn off the NVR and unplug the power cable.
Connect the eSATA device and then power the NVR
back on. To disconnect an eSATA device, first turn
off the NVR and unplug the power cable. Turn off
the eSATA device and then disconnect the eSATA
connection cable.
Factory Reset
Located next to the eSATA port on the rear of the NVR is
a switch that, once activated, will reset the NVR to all its
initial factory settings.
A factory reset will clear all NVR settings configured by
the user.
You will need a straightened paper clip to access the
factory reset button.
1
Turn off the NVR and unplug the power cable.
2
Insert a straightened paper clip into the factory reset
switch hole and press the switch.
3
While holding the factory reset switch, power the
NVR on.
4
Once the front panel LEDs start to flash, remove the
paper clip. A beep sounds.
5
All NVR settings will be returned to their factory
values and the NVR restarts.