Part 1 – Introduction
11
Rear Panel
2
1
3
4
5
6
1
Power In Port
2
Vent
3
Network Ports
4
USB Port
5
eSATA Port
6
Factory Reset Button
Rear Panel Connections
Power Cable Connection
Connect the power cable to this port. This NVR does not
feature a separate power on/off button and will turn on
the moment power is supplied.
• Organize the power cable so that it will not cause
people to trip over or become damaged from chairs,
cabinets, desks, and other objects in the vicinity. Do
not run the power cable underneath a rug or carpet.
• The power cable is grounded. Do not modify the
power plug even if your power outlet does not have
a ground contact.
• Do not connect multiple devices to a single power
outlet.
Network Connection
This NVR is capable of connecting to networks via an
ethernet connector. Connect an RJ-45 cable (Cat5,
Cat5e, or Cat6) to the NVR's network port. It's possible to
operate and upgrade the NVR remotely over a network.
Fore more information on ethernet connection setup,
refer to
Network Setup on page 30
.
•
Connector directions may vary depending on the
NVR model.
•
Green LED on the right will be lit if connected a
1000 BASE-T network. Orange LED on the left will
flicker once a link has been established.