Eneo HDD-20, Руководство по установке

Страница: 9 / 92

Installation Guide
9
RS-485 is the interface that communicates the Camera and its control device;
for this reason, the RS-485 setup of the Camera and the control device must
be the same. The RS-485 default setting is half-duplex (see the diagram
follows). Please do not change the default setting without qualified specialist or
supplier’s notice.
RS-485 Setting
Half-duplex Full-duplex
3.1.3 ID Setup
Please assign an ID number to a Camera if there is more than one Camera in
the same network. The camera’s ID can be setup using the 10-bit ID Dip
Switch, which is located on the Camera’s back plate. If the Camera’s ID
number is 6, for instance, the ID switch SW 2 and SW 3 should be set to “ON”
and the rest should be set to “OFF” as shown below. Dip Switch configuration
for ID No. 0~10 are listed in the table below. To complete ID setups, please
refer to the User Manual (up to page36).
For switch configuration details, please refer to User Manual > Appendix B:
Switch Settings Index Table.
NOTE:
No two Cameras should be given the same ID, or
communication conflict may occur.