Endress+Hauser Waterpilot FMX21, Руководство по эксплуатации

Страница: 79 / 144

Waterpilot FMX21 Repair
Hauser 79
12 Repair
12.1 General information
12.1.1 Repair concept
Repairs are not envisaged for the device.
12.1.2 Replacing a device
Once a complete device has been replaced, the parameters can be transferred back into the
device using FieldCare:
Prerequisite: The configuration of the old device was saved previously to the computer
using FieldCare.
You can continue to measure without performing a new calibration.
12.2 Spare parts
All the spare parts for the measuring device, along with the order code, are listed in the
W@M Device Viewer ( www.endress.com/deviceviewer ) and can be ordered. If available,
users can also download the associated Installation Instructions.
Measuring device serial number:
• Located on the device and spare part nameplate.
• Can be read out via the "Serial number" parameter in the "Instrument info" submenu.
12.3 Return
The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the web page for information:
http://www.endress.com/support/return-material
 Select the region.
2. Return the device if repairs or a factory calibration are required, or if the wrong
device was ordered or delivered.
12.4 Disposal
If required by the Directive 2012/19/EU on waste electrical and electronic equipment
(WEEE), the product is marked with the depicted symbol in order to minimize the
disposal of WEEE as unsorted municipal waste. Do not dispose of products bearing this
marking as unsorted municipal waste. Instead, return them to the manufacturer for
disposal under the applicable conditions.