Endress+Hauser RMA42, Руководство по эксплуатации

Страница: 19 / 64

RMA42 Commissioning
Hauser 19
6 Commissioning
6.1 Post-installation check and switching on the device
Make sure that all post-connection checks have been carried out before you commission your
device:
• ‘Post-installation check’ checklist in Section 3.5
• ‘Post-connection check’ checklist in Section 4.2
Once the operating voltage is applied, the display lights up and the green LED indicates that the
device is operational.
When you commission the device for the first time, you program the setup in accordance with the
descriptions provided in these Operating Instructions in the following sections.
When commissioning a device already configured or preset, measuring is immediately started as per
the settings. The values of the channels currently activated appear on the display. Changes to the
display can be made in the Display menu item (
→
Chap. 6.4.7 ‘Step 7: Configuring the display
functions’).
!
Note!
Remove the protective foil from the display as this restricts display legibility otherwise.
6.2 General information on the device configuration
You can commission/configure your device locally using the three integrated keys, or by PC. You
require the Commubox FXA291 to connect the device to a PC (see ‘Accessories’ section).
Advantages of configuring the device using FieldCare Device Setup:
• The device data are saved in the FieldCare Device Setup and can be called up at any time.
• Entries can be made more quickly using the keyboard.
6.3 Notes on setup access protection
Access to the setup is enabled when the device leaves the factory. Access can be locked via the
setup.
Proceed as follows to lock the device:
1. Press ‘ E ’ to get to the configuration menu
2. Press ‘ + ’ , ‘ Setup ’ is displayed
É
, press ‘ E ’
3. Press ‘ + ’ again until ‘ System ’ is displayed, press
É
‘ E ’
4. ‘ Access code ’ is displayed, press
É
‘ E ’
5. Set the code: the desired numerical value is configured by pressing the ‘ + ’ and ‘ - ’ keys. The
access code is a four-digit number. The corresponding position of the number is displayed in
plain text.
To confirm the value entered and to go to the next position, press ‘
E ’.
6. Confirm the last position of the code to exit the menu. The code is displayed in full. Press ‘ + ’
to scroll to the last point of the ‘ x Back ’ submenu and confirm this point. As a result, the value
is accepted and the user returns to the level of the ‘ Setup ’ item. Also exit this submenu via the
last ‘ x Back ’ parameter to get back to the measured value/channel display.
!
Note!
The ‘
x Back ’ point can be found at the end of every picklist/menu item. If you confirm this
parameter, you go from the submenu to the higher-order menu, or you exit the setup.