Endress+Hauser Proline Promass A 100, Руководство по эксплуатации

Страница: 49 / 56

Proline Promass A 100 Commissioning
Hauser 49
10.3 Configuring the device address via software
Applies only to device version with EtherNet/IP communication type
Software addressing is carried out in the Communication submenu.
Navigation path
"Setup" menu → Communication
When delivered, the measuring device has the following factory settings:
Ethernet network and Web server
IP address 192.168.1.212
Subnet mask 255.255.255.0
Default gateway 192.168.1.212
• If hardware addressing is active, software addressing is disabled.
• If a switch is changed to the "ON" position, then the first three octets of the
software address are retained.
If the IP address of the device is not known, the device address currently
configured can be read out: Operating Instructions for the device
10.4 Configuring the measuring device
The Setup menu with its submenus is used for fast commissioning of the measuring
device. The submenus contain all the parameters required for configuration, such as
parameters for measurement or communication.
Submenu Meaning
System units Configuring the units for all measured values
Medium selection Defining the medium
Communication Configuration of the digital communication interface
Low flow cut off Configuring the low flow cut off
Partial filled pipe detection Configuring the monitoring of partial and empty pipe
detection
10.5 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the "Device tag" parameter and thus change the factory
setting.
Navigation
"Setup" menu