Endress+Hauser Proline Promass A 100, Руководство по эксплуатации

Страница: 39 / 56

Proline Promass A 100 Electrical connection
Hauser 39

A0013960
5. Insert dummy plugs into unused cable entries.
7.5 Post-connection check
Are cables or the device undamaged (visual inspection)? 
Do the cables comply with the requirements (→  23)? 
Do the cables have adequate strain relief? 
Are all the cable glands installed, firmly tightened and leak-tight? Cable run with "water trap"
(→  38) ?

Depending on the device version: are all the device plugs firmly tightened (→  31)? 
• Does the supply voltage match the specifications on the transmitter nameplate ?
• For device version with Modbus RS485 intrinsically safe: does the supply voltage match the
specifications on the nameplate of the Safety Barrier Promass 100 ?

Is the terminal assignment or the pin assignment of the device plug (→  26) correct? 
• If supply voltage is present, is the power LED on the electronics module of the transmitter lit
green (→  8)?
• For device version with Modbus RS485 intrinsically safe, if supply voltage is present, is the
power LED on the Safety Barrier Promass 100 lit (→  8)?

Depending on the device version, is the securing clamp or fixing screw firmly tightened? 