Endress+Hauser Proline Promag W 400 HART, Руководство по эксплуатации

Страница: 124 / 198

Diagnostics and troubleshooting Proline Promag W 400 HART
124 Hauser
Error Possible causes Solution
No or incomplete display of
contents in the Web browser • JavaScript not enabled
• JavaScript cannot be enabled 1. Enable JavaScript.
2. Enter http://192.168.1.212/
basic.html as the IP address.
Operation with FieldCare or
DeviceCare via CDI-RJ45 service
interface (port 8000) Firewall of computer or network is
preventing communication Depending on the settings of the
firewall used on the computer or in
the network, the firewall must be
adapted or disabled to allow
FieldCare/DeviceCare access.
Flashing of firmware with FieldCare
or DeviceCare via CDI-RJ45 service
interface (via port 8000 or TFTP
ports) Firewall of computer or network is
preventing communication Depending on the settings of the
firewall used on the computer or in
the network, the firewall must be
adapted or disabled to allow
FieldCare/DeviceCare access.
12.2 Diagnostic information via light emitting diodes
12.2.1 Transmitter
Different LEDs in the transmitter provide information on the device status.
LED Color Meaning
Supply voltage Off Supply voltage is off or too low
Green Supply voltage is ok
Link/Activity Orange Link available but no activity
Flashing orange Activity present
Communication Flashing white HART communication is active.
Alarm Green Measuring device is ok
Flashing green Measuring device not configured
Off Firmware error
Red Main error
Flashing red Error
Flashing red/green Start measuring device