Endress+Hauser ASP Inline, Руководство по эксплуатации

Страница: 44 / 80

Maintenance ASP Inline
44 Hauser
function is controlled by means of relay output 4. The assembly must be connected to an industrial
water network available at the client's site.
SETUP -> BASIC SETTINGS -> Sampling -> Rinsing -> YES ->
!
Note!
For the correct operation of the rinsing function, the ASP Station 2000 has to have a rinsing point
with a drain for the tap.
Fig. 16: "Rinsing" sampling function, ASP Inline (via ASP Station 2000 controller)
The following settings can be made:
With the standard SW version, configure output 1 for this purpose at the controller of ASP Station
2000 as follows:
SETUP -> BASIC SETTINGS -> OUTPUTS -> OUTPUT 1
Under "FUNCTION", select "RINSING"
6.4.3 Purge
The ASP Inline sampler assembly is optionally available with a purge function with compressed air.
From the ASP Station 2000 with SW version LDB64XA (or higher e.g. LDB65XA), this function is
controlled by means of relay output 5. External assembly compressed air supply is required for
purging.
SETUP -> BASIC SETTINGS -> Sampling -> Purge -> YES ->
Fig. 17: "Purge" sampling function, ASP Inline (via ASP Station 2000 controller)
The following settings can be made:
With the standard SW version, configure output 2 for this purpose at the controller of ASP Station
2000 as follows:
SETUP -> BASIC SETTINGS -> OUTPUTS -> OUTPUT 2
Under "FUNCTION", select "Purge"
7 Maintenance
#
Warning!
• Do not open the assembly's cover to perform maintenance work whilst the assembly is in
operation.
Time The time the tap waits at the rinsing point on completion of the rinsing process. The time is
needed to drain the distributing arm over the rinsing point. Adjustable from 0-99 sec.
Delay Time for rinsing the dosing chambers with industrial water. Adjustable from 0-99 sec.
Time The time for purging with compressed air. Adjustable from 0.0-9.9 sec.
Delay Waiting time. Adjustable from 0-99 sec.