E9 IN REV. A
18
2. Press and hold the valet switch, the timer will immediately start.
3. When the desired interval has passed, release the valet switch. 1 long chirp for confirmation. (Set to any
interval between 1 second and 2 minutes)
Note 1
:
If your built-in timer controls window/sunroof closure in your car DO NOT change the timer setting! This requires
installer-only programming. Changing the value will adversely effect operation and may cause damage.
Note 2:
Latched output
= The latched output selection will send a negative signal as soon as the Channel 4 button is
pressed and will continue until the button is pressed again.
Latched output / reset with ignition
= The latched / reset with ignition output selection operates just like the latched
output but will reset or stop when the ignition is turned on.
Password Pin Code Setup:
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 5 times and stay in OFF position.
2. Push the Valet switch 5 times (holding in on the 5th push) until one long chirp is heard then release the valet switch.
You are now in the Alarm feature
“C”
programming mode. You can program or delete the password pin code as
below:
Program:
1. Press and release the transmitter
button twice, [2] LED flash, [2] siren/horn chirp to indicate that you are in
features “Password Pin Code Programming mode”.
2. Within 5 seconds, begin to enter your chosen first 9ths digit by pressing and releasing the valet Switch from 1 – 9
times.
3. Within 15 seconds of the last entered 9ths digit, turn the Ignition switch to “ON” position.
4. Within 15 seconds, enter your chosen second 9ths digit by pressing and releasing the valet Switch from 1 – 9
times.
5. Finish by turning the ignition switch to “OFF” position.
If the new password code was accepted, the unit would report back the newly entered code, by flashing the LED, first
indicating the first digit code has been memorized, pause and then the second digit code. The unit will report the new
code three times with a one-second’s pause between each code.
Note: If 15 seconds of inactivity expire, or if the ignition switch is turned “ON” for more then 5 seconds during of above
steps, the unit will revert back to the last successfully stored code. A [3] long chirps to confirm exit. Will revert back to
the last successfully stored code
Delete Password Pin Code / Override Without Password Pin Code (Factory default setting):
Within 15 seconds, press and hold the transmitter
button for 3 seconds. One long chirp is heard to confirm
Deleted the Password Pin Code.
Example: To program the Password Code 92, you would;
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 5 times and stay in OFF position.
2. Push the Valet switch
5 times (holding in on the 5th push)
it until one long chirp is heard then release the valet
switch. You are now in the Alarm feature
“C”
programming mode.
Program:
1. Press and release the transmitter
button twice, [2] LED flash, [2] siren/horn chirp to indicate you are in
features “Password pin code programming mode”.
2. Within 5 seconds, press and release the valet Switch 9 times.
3. Within 15 seconds of the last entered 9ths digit, turn the Ignition Switch to “ON” position.
4. Within 15 seconds press the valet Switch twice.
5. Turn the Ignition Switch to “OFF’ position.
You will note the LED flashing nine times, pause and then flash two times, pause. This pattern will be repeated three
times indicating the new code (92) has been accepted and stored in memory.
Exit:
Press any button (except
button) of the transmitter to exit the password pin set up mode.
REMOTE START FEATURE PROGRAM MODE.
START FEATURE “D” PROGRAMMING: