Empire Comfort Systems DVP42 Series, Инструкция по установке и руководство пользователя, Страница: 39 / 72

31455-4-1113 Page 39
LOG PLACEMENT (4 LOG SET)
Before you begin: If you are installing logs into the DVP42 or DVP48
model then this fireplace is supplied with a set of four ceramic fiber
logs. Do not handle these logs with your bare hands. Always wear
gloves to prevent skin irritation from ceramic fibers. After handling
logs, wash your hands gently with soap and water to remove any
traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace. Please refer to Figure
70, Figure 71, and Figure 72 and corresponding WARNING, when
completing the following log placement steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox
4. Place rear (#1) log onto two pins on rear log support.
5. Place left, front (#2) log onto two left, front pins on burner pan.
6. Place right, front (#3) log onto two right, front pins on burner
pan.
7. Place Branch (#4) onto one pin on rear log and one on front
left log (#2).
8. Place decorative rock in front of grates and sides of main burner.
ATTENTION : Do not place decorative rock on logs or on burner.
The decorative rock should only be placed on the fireplace floor.
9. After all logs are properly positioned, place small “dime” size
pieces of Rockwool lightly across the front round “blueflame”
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports. See Figure 70.
10. Replace glass door onto firebox.
11. Secure the two glass frame spring clamps at bottom of firebox.
12. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
13. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
Figure 70
F igure 71
WARNING: Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
Figure 72
LOG SET PARTS LIST
INDEX
NO.
PART NO.
DESCIPTION
DVP42 DVP48
1 R10349 R10357 REAR LOG
2 R10350 R10358 FRONT LEFT LOG
3 R10351 R10359 FRONT RIGHT LOG
4 R10352 R10360 TOP BRANCH
WARNING: If flame lifts off burner and goes out, verify
insulation and retainer were removed. See page 24.