Empire Comfort Systems Boulevard VFLL60FP90LN-1, Руководство пользователя

Страница: 23 / 60

36776-2-0816 Page 23
1. Insert fireplace into enclosure.
2. Level fireplace.
3. Secure three standoff brackets with drywall screws to the
framed opening above the fireplace as shown in Figure 28.
Notice : The drywall screws are located in the instruction
envelope packet. Secure fireplace on left and right through
side nailing flanges.
4. Install the fireplace so that non-combustible board is installed
over the fireplace cabinet face, secure the top and side
nailing flanges flush with the face of the fireplace cabinet.
Note: Installation of a decorative front is recommended to
provide the cleanest finished look.
5. Check gas lines for leaks.
6. Plug AC adapter and LED transformer to junction box.
7. Install the wall-mounted control box within 10 feet of
the center of the fireplace. (See Figure 28)
WALL MOUNT
CONTROL BOX
10 FEET
MAX
SCREW INTO
EACH BRACKET
6” MIN
CENTER
OF
FIREPLACE
Figure 28
8. Install a plastic bushing in both the liner and outer walls of
the fireplace. (See Figure 29 & 30)
Figure 29
Figure 30
9. Route the yellow LED wire harness, grey remote receiver
harness,and red/black battery backup harness through the
bushings to the wall. Mount controls and connect.
(See Figure 31)
REMOTE
SWITCH
COVER PLATE
YEL/BLACK
GRAY EXTENSION
WIRE
YELLOW EXTENSION
WIRE
RED/BLACK
TO FIREPLACE
TO FIREPLACE
Figure 31
10. Set receiver in wall box to remote. Set switch on side of heat
shield to standing pilot or intermediate pilot.
FIREPLACE & NONCOMBUSTIBLE BOARD
INSTALLATION - CLEAN FACE