EMI CAC_36, Инструкция по установке, эксплуатации и обслуживанию

Страница: 25 / 52

www.enviromaster.com
25 Cassette Air Handler
SEqUENCE Of OpERATION
The optional
Infrared Hand Held Controller
has a useful transmission distance approxi
-
mately twenty (20) feet when perpendicular
to the face of the Cassette. However, this
distance will vary and decrease when the
angle of transmission is not perpendicular.
This distance may also vary depending on
the lighting in the room.
If there is no activity on the Infrared Hand
Held Controller for ten (10) minutes, it will
enter a hibernate Mode
and the display
will go dark. While in
hibernate Mode ,
pressing any button will awaken the
op-
tional
Infrared Hand Held Controller. The
optional
Infrared Hand Held Controller will
awaken in the last mode it was in prior to
entering hibernate Mode.
Table #2 Configuration Mode
Setting Item LCD Title Display Possible Value (Flashing) Factory Settings
1) - Temperature scale “01 F-C”
“F” (Fahrenheit)
“C” (Celsius)
“F”
2) - Heat Source “02 HEAT”
“ON” (Heat source available)
“OFF” (Not available)
“ON” If El. heat
“OFF” If no El. Ht.
3) - Heat pump
(This setting is skipped if Heat source
setting is “Off” as it’s not needed)
“03 H-P”
“ON” (Heat pump available)
“OFF” (Not available)
“OFF”
4) - Auto-changeover differential
(This setting is skipped if Heat source
setting is “Off”) Used with optional In-
frared Hand Held Controller for heat-
ing/cooling change over.
“04 d-b” Between “2 – 6” degrees “2”
5) - Check filter time “05 F:Lt”
“2” (250 hours)
“5” (500 hours)
“7” (750 hours)
“10” (1000 hours)
“12” (1250 hours)
“10”
CONFIgURATION MODE:
for optional
Infrared Hand Held Control
-
ler operation, the control must be con
-
figured through the Configuration Mode
.
While the unit is in the off Mode
, press
-
ing the MoDE + PRogRAM buttons
simultaneously for five (5) seconds will
enter the
Configuration Mode
. While in
Configuration Mode, pressing the MODE
+ PRogRAM buttons simultaneous-
ly again or left idle for twenty (20) sec
-
onds, will save the new settings and exit
the
Configuration Mode.
While in
Configuration Mode , pressing the
UP or DoWN ARRoW buttons will allow
for selection of the value. Pressing the
PRogRAM
button will advance to
the next selection. Table #2
specifies the
user selectable settings in the
Configura
-
tion Mode: