Emerson Rosemount X-well 648, Справочное руководство

Страница: 18 / 90

8
Reference Manual
00809-0200-4648, Rev BB
Configuration
July 2016
Configuration
Figure 2-6. Rosemount 185 Thermocouple
Note
Wire color examples apply to Rosemount sensors, but will vary by manufacturer.
Sensor leads
If the sensor is installed in a high-voltage environment and a fault condition or installation
error occurs, the sensor leads and transmitter terminals could carry lethal voltages. Use
extreme caution when making contact with the leads and terminals.
Use the following steps to wire the sensor and supply power to the transmitter:
1. Remove the transmitter enclosure cover (if applicable).
2. Attach the sensor leads according to the wiring diagrams.
3. Connect the power module.
4. Verify the connection by observing the LCD display (if applicable).
5. Reattach and tighten the cover (if applicable).
2.4 Bench top configuration
Bench top configuration consists of testing the transmitter and verifying transmitter
configuration data. The Rosemount 648 Wireless must be configured before installation,
which may be performed either directly or remotely. Direct configuration can be performed
using a Field Communicator, AMS Device Manager, AMS Wireless Configurator, or any
Wireless HART
®
Communicator. Remote configuration can be performed using AMS Device
Manager, AMS Wireless Configurator, or the Smart Wireless Gateway.
The power module must be installed to provide power to the Rosemount 648 Wireless for
configuration. To communicate to the transmitter, begin by removing the power
module-side housing cover, indicated as “Field terminals” by text located on the side of the
device. This will expose the terminal block and HART
®
Communication terminals, which are
labeled “COMM”. Connect the power module to supply power for configuration. See
Figure 2-7 .
Type J Type N
Type K
+ Black (2)
– White (3)
+ Pink (2)
– White (3)
+ Green (2)
–
White (3)