IC200CX EVO
user manual
35
PARAMETER PROGRAMMING
10
10.1 Programming from keyboard
The values of all the parameters can be changed through the keypad. The parameters of the
controller have been gathered into families, each of which is identified with a label. This enables the
user to quickly access the parameters concerned in the various levels.
•
ALL
All parameters
•
St
Thermoregulation parameters
•
CF
Configuration parameters
•
Sd
Dynamic set point parameters
•
ES
Double set point parameters
•
Cr
Compressor control unit parameters (not used)
•
CO
Compressor/pump parameters
•
US
Auxiliary output parameters
•
FA
Fan parameters
•
Ar
Antifreeze heater parameters
•
Df
Defrost parameters
•
FS
Domestic hot water management parameters
•
AL
Alarm parameters
There are 3 parameter programming/editing levels:
1.
Pr1
user level (common parameters);
2.
Pr2
customer support level (unit settings, reserved for Service);
3.
Pr3
manufacturer level (unit configuration, reserved).
10.2 How to enter in programming mode in level Pr1
Simultaneously press the and buttons
for 3 sec; the upper display shows the PAS label and
the lower display shows the
Pr1
label (level Pr1).
Press the button and then the
0
will start to
flash on the upper display.
3 seconds