Emerson HF1160BQ02, Руководство пользователя

Страница: 13 / 72

13
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: HF1160-2
6. Wall Control Installation
6.1
General Information
The SW95 Wall Control is designed to operate only
one ceiling fan, and Not an accessory light kit.
The SW95 Wall Controls do not require a receiver.
The SW95 Wall Control is rated for 1.25 Amp,
120 VAC, 60 HZ full load.
6.2
Installation of Wall Control replacing an
Existing Wall Control:
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install the
ceiling fan mounting plate on the outlet box.
NOTE: The ceiling fan must be set at the highest
speed setting before installation of the Wall Control.
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
WARNING
!
To avoid erratic speeds and possible damage to your
ceiling fan, use the Wall Control only with fans pull
chain switches set to their high speed settings.
All ceiling fans must be completely installed before
installation of the Wall Control.
Your new Wall Control will require a grounded
electrical supply line of 120 volts AC, 60 HZ circuit.
6-3 SCREWS (2)
FACEPLATE
WALL OUTLET BOX
SWITCH
Figure 21
6.3
Remove the faceplate and the two 6-32 screws from the
existing wall switch (retain faceplate and screws for future
use) (Figure 21).
BP7272-4 HF1160.qxp_BP7272 9/10/15 9:44 PM Page 13