Emerson Daniel Danalyzer 1000, Справочник по аппаратуре

Страница: 178 / 320

SEP 2005
MODEL 1000
MAINTENANCE
5-10
14. Analog Output 6 High Same as number 9.
15. Analog Output 7 High Same as number 9.
16. Analog Output 8 High Same as number 9.
17. Analog Output 9 High Same as number 9.
18. Analog Output 10 High Same as number 9.
19. Analog Output 1 Low M easured value program for output lower than
operator specified zero range.
20. Analog Output 2 Low Same as number 19.
21. Analog Output 3 Low Same as number 19.
22. Analog Output 4 Low Same as number 19.
23. Analog Output 5 Low Same as number 19.
24. Analog Output 6 Low Same as number 19.
25. Analog Output 7 Low Same as number 19.
26. Analog Output 8 Low Same as number 19.
27. Analog Output 9 Low Same as number 19.
28. Analog Output 10 Low Same as number 19.
29. Analyzer Failure Carrier gas low (below 105 PSIG at bottle) or gone;
bad solenoid; carrier gas leak in system.
30. Power Failure The GC Controller has experienced a re-start since
alarms were last cleared, caused by power failure.
Automatically starts in RUN mode and runs Cal gas
until it identifies all retention times or a maximum of
two hours before switching to line gas.
31. Fused Peak Overflow - Noisy
Baseline Air not purged from carrier lines; bad thermistors;
preamp out of balance or failed.
32. RF % Deviation Calibration gas low or out; valve timing error; faulty
auto-calibration solenoid.
33. W arm Start Calibration fails Same as number 32.