Emerald Home 3, Паспорт и руководство по эксплуатации

Страница: 10 / 33

9
General rules for handling quick fittings like John Guest®.
The connection of the white ¼ tube to the fittings can be done manually or using the special
key included in the package. Quick-release joints of the John Guest® type allow, if it is necessary,
to carry out procedures for connecting / disconnecting the tubes and the fittings multiple times.
Important! Do not apply the
force when performing these
procedures!
The correct
connections / disconnections
of tubes and fittings like John
Guest®
do not require
excessive force!
To connect the tube to the fitting the following actions should be done:
u
Insert the white tube until it stops in the hole of the fitting; If the connection is right then the
tube enters the fitting hole by 15-18 mm;
u
Check the reliability of tube connection by countermotion of the tube. At the countermotion
of the tube the end ring (collet sleeve) of the fitting extends from the base;
u
A retaining lock (blue / red clip) is inserted into the gap between the end ring (collet sleeve)
and the base of the fitting.
To disconnect the tube from the fitting:
u
Temporarily remove the retaining lock (blue / red clip) from the fitting;
u
Press the end ring (collet sleeve) of the fitting to the base of the fitting by the hand or with
special key and hold it in this position while pulling out the white tube;
u
Pull the tube out of the fitting hole.
Fig. 6 General Principles of Connecting the tubes to Quick Release John
Guest® Fittings