Emerald Home 3, Паспорт и руководство по эксплуатации

Страница: 23 / 33

22
u
After 10 minutes of WASH OUT stage, the LED will light up in standard green color, indi-
cating that the FLUSHING mode has been successfully finished and the device has entered
the full OPERATION mode (is ready for normal usage).
Некоторые особенности режима ПРОМЫВКА.
В процессе заполнения Установки раствором кислоты, до ее ВЫДЕРЖКИ, допускается
многократное включение/отключение промывного насоса.
В режиме ПОЛОСКАНИЕ употреблять воду из-под крана категорически запрещено.
Some features of the FLUSHING mode.
u
User can always pause the automatic FLUSHING mode and start it again by repeated pressing of
the button ( Fig. 18- “ 10 ” ). This function allows the user to suspend the FLUSHING mode if
there are problems with pumping the washing solution into the device and resume this mode
again. During the RETENTION stage user can turn on/off the flushing device for several times
so as to pump the additional flushing solution into the device (if necessary);.
u
FLUSHING mode is non-volatile and has priority. That is, when the network disappears and
when it reappears, the device will automatically enter the stage of the FLUSHING mode from
which it was removed by disconnecting the network. It protects the user from the risk of acci-
dental ingestion of a citric acid solution in the body if the FLUSHING mode is violated.
u
Important! If during the FLUSHING of the device there were any malfunctions that could inter-
rupt the course of the FLUSHING mode, please repeat the FLUSHING procedure before using
the device. If faults are detected during the FLUSHING mode, it is necessary to additionally
make sure that the washing solution was successfully flushed with tap water from the device
for 10 minutes before starting to use the device in normal mode.
Important! To increase the useful life of the flushing device, it is suggested that after carrying
out maintenance procedures user should rinse thoroughly the intake part of pump, the holding tank
for flushing solution and connecting hoses of the flushing device with warm tap water so as to wash
out residues of the citric acid crystals. After flushing, all elements of the flushing device must be
dried and removed to dry and clean place while waiting for the next flush. The FLUSHING proce-
dure of the main elements of the flushing device must also be repeated at the beginning of future
flushing procedures to ensure the smooth operation of the device.
Important !
It is forbidden to disconnect a working device (in OPERATION or FLUSHING mode)
from the network by pulling the plug of the power source from the device. This can lead to malfunc-
tioning of the device. Disconnecting devices from the power supply should only be done by discon-
necting the power plug from the outlet.