EMBRON Hatteland HD 19T22, Руководство пользователя

Страница: 35 / 142

35 Installation
IND100078-33
Installation Procedures
Mounting Bracket, Table / Desktop / Ceiling - 24, 26 and 27 inch
You need: M5 Unbrako® Hex Key tool and 1 pcs of HD TMB SX1-C1 Mounting Bracket Kit. Fasteners (6 pcs M6) for
Table / Desktop location not included. Procedure suitable for: Display and Panel Computers. 24 inch unit used as
illustration below, but same procedure apply for 26 and 27 inch units as well.
Attention: A suitable pre-drilled location should be prepared and checked prior to mounting.
Please disconnect ALL cables before proceeding. Please review User Manual or visit
www.hattelandtechnology.com for Technical Drawings regarding measurements for both main unit
and Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface
(i.e. table) with the glass front facing down as
illustrated. Connector area should be facing
downwards from you.
▼ 2: Inspect the mounting holes of brackets. For mounting
to a 24 inch unit, please use the lower holes as indicated.
For mounting to a 26 / 27 inch unit, please use the upper
holes as indicated.
Seen from
above
Connector Area
24 inch
26 inch
27 inch
▼ 3: Place one bracket at the time with the mounting
holes facing down into the suitable mounting
position and fasten with 2 x M5 screws on each
bracket. Torque Force 3.5Nm.
▼ 4: While unit is lying flat on table, check the Tilting Lock
Pin position. These can be pulled out by hand, turned 90°
(FIG1) and turned back 90° until the Lock Pin automatically
clicks into place by a spring (FIG2).
FIG1
FIG2
FIG2
FIG1
FIG2
Locked Unlocked