EMBRON Hatteland HD 19T22, Руководство пользователя, Страница: 33 / 142

33 Installation
IND100078-48
Installation Procedures
Mounting Bracket, Table / Desktop / Ceiling - 15, 17 and 19 inch
Procedure suitable for: Display (MMD) and Panel Computer (MMC) Series X Generation 2 (G2) product ranges.
19 inch Maritime Multi Display (MMD) used as example below.
You need:
- M3 Unbrako® Hex Key tool (not included with delivery).
- Fasteners (6 pcs M6) for mounting complete unit onto table or desktop location (not included with delivery).
- 1 pcs of HD TMB SX2-A1 Mounting Bracket Kit (including pre-mounted 6 x M6x6mm Set Socket Screws).
Attention: Please disconnect ALL cables before proceeding. Please review User Manual or visit
www.hattelandtechnology.com for Technical Drawings regarding measurements for both main unit
and Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface (i.e.
table) with the glass front facing down as illustrated.
Connector area should be facing downwards from you.
▼ 2: The two bracket pieces comes pre-mounted as shown below.
Both sides are identical. Prepare the drilling, location of holes
indicated in the footprint below. Drill 6 pcs of 6mm holes in your
table/desktop location.
Seen from
above
Connector Area
▼ 3: Identify the 3 x Set Socket Screw (M6x6mm) and
slightly loosen two of them, now tilt the upper part until
you reach an approximate position you need and tighten
them slightly.
▼ 4: Mount the brackets onto unit as indicated with 2 pcs M4x35
DIN912 screws (included) on both sides. Use Torque Force 2Nm.
Connector Area