EMBRON Hatteland HD 19T22, Руководство пользователя, Страница: 32 / 142

32 Installation
IND100078-36
Installation Procedures
Panel Cutout / Console Mounting Bracket Kit for 26 inch
You need: Torx T25 tool, 1 pcs of HD CMB SX2-F1 kit (included in delivery).
Procedure suitable for: Display and Panel Computers Series X Generation 2 range. Brackets are EN60945 Tested.
Attention: A suitable pre-cut panel cutout should be made prior to mounting. Do not force the
unit into the panel cutout as it might break the outer glass or scratch the chassis on the unit. Make
sure that the panel cutout is not too tight for the unit. Please disconnect ALL cables before
proceeding. Please re-check the relevant and required panel cutout measurements if unsure.
Item Amount Art Description
4 P007085-1 Bracket HD 26T2x SH-A
8 145 050X016 ZT Panskrue M5x16 Torx, blank
8 144 064x120x22 M6 C-washers DIN6319 Steel
▼ 1: Slide the unit into the cutout carefully. User
Controls and Connector Area should be facing
downwards.
▼ 2: Place and mount the 4 x brackets as illustrated
below.
▼ 3: Secure each bracket with the provided M5x16
screws and C-Washers as illustrated below. Make sure
you do it equally and even for all 4 sides. Use Torque
Force 3.75Nm, 2 screws and 2 washers pr. bracket. Note
the orientation of brackets before you begin.
▼ 4: Review closeup of the mounting of brackets with
screws and C-Washers in place. Seen from bottom side.
Washer
Screw
Bracket