EMBRON Hatteland E Series, Руководство пользователя

Страница: 34 / 136

Physical Connections
34
IND100133-74
POWER INPUT DC:
Connect your DC power cable to the 2-pin Terminal Block 5.08 connector. The internal DC power module supports
24VDC. Please check specifications for your unit.
POWER INPUT AC:
The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input. Please check
specifications for your unit.
GROUNDING SCREWS:
Grounding screw shall always be used for both DC and AC inputs. Please review “General mounting instructions” in
the “Installation” chapter, pt. 7 for more information.
Note for Grounding Screws:
Standard Grounding Screw/Bolt provided by Hatteland Technology is “Pan head screws M4x8mm w/spring and plain
washer”.
Multi-power note: (For units supporting AC & DC input simultaneously)
The unit has a dual input power supply which will accept both AC and DC input. If both inputs are connected, the unit will be
powered by AC. If AC is disconnected it will automatically switch over to DC without affecting the operation of the unit. This makes
it possible to use AC power as primary power and a 24V battery as secondary power, eliminating the need for expensive UPS
systems.
DisplayPort (DP++) (1,2) OUT
:
Enables two signal outputs from the computer. Use a DP++1.2 compliant 20 pins cable. The DP has its own locking
mechanism that locks the plug inserted. Make sure the plug “clicks” into place to verify a proper and secure
connection.
DisplayPort note:
This system supports 3 active panels, but please note that some pre-boot environments do not support more than 1-2 active
panels. The system priority in these cases are as follows:
- Onboard LVDS (Panel) is always detected as Main display.
- If only one DP++ output is connected this will become the secondary display.
- If both DP++ outputs are connected, DP++ 2 will be Secondary and DP++ 1 will be Third display.
The DP++ 1 port may then not show any picture until after OS is loaded.
Reduce Cable Tension
To reduce tension on the cables you connect, secure them with
a cable tie to the available chassis hinges located near the
connectors. Note that the actual position of these hinges may
vary depending on the specific unit.