EMBRON Hatteland E Series, Руководство пользователя

Страница: 29 / 136

29 Installation
IND100078-72
Installation Procedures
Mounting Bracket, Table / Desktop / Ceiling - 15.6 inch
You need:
- M3 Unbrako® Hex Key tool (not included with delivery).
- Fasteners (6 pcs M6) for mounting complete unit onto table or desktop location (not included with delivery).
- 1 pcs of HD TMB SE1-A1 Mounting Bracket Kit (including pre-mounted 6 x M6x6mm Set Socket Screws).
Attention: Please disconnect ALL cables before proceeding. Please review User Manual or visit
www.hattelandtechnology.com for Technical Drawings regarding measurements for both main unit
and Mounting Brackets.
▼ 1: Place the unit on a dry, flat, clean, soft surface (i.e.
table) with the glass front facing down as illustrated.
Connector area should be facing downwards from you.
▼ 2: The two brackets comes pre-mounted as shown below.
Prepare the drilling, location of holes indicated in the footprint
below. Drill 6 pcs of 6mm holes in your table/desktop location.
Seen from
above
Connector Area
▼ 3: Identify the 3 x Set Socket Screw (M6x6mm) and
slightly loosen two of them, now tilt the upper part until
you reach an approximate position you need and tighten
them slightly (final mounting in step 6).
▼ 4: Mount the brackets onto unit as indicated with 3 x M5x10
Panhead Torx screws (included) on both sides. Use Torque Force
4Nm.