EMAK PW 146C, Инструкция для оператора

Страница: 9 / 56

9
The warning labels (5) inform you of any other risks, such as: do not use the high pressure cleaner unless
you have read the instructions manual; do not use the high pressure cleaner for washing people, animals,
electrical equipment or the high-pressure cleaner itself.
WARNING
• After removing the appliance from the packing materials, check that the identification label and the
warning labels are present and are legible. If this is not the case, contact your dealer or an authorised
service centre so they can be replaced.
• If the identification label and the warning labels deteriorate during use, contact your dealer or an
authorised service centre so they can be replaced.
3.2 s
tandard
a
ccessorIes
Make sure that in the product package that was bought there are the following elements:
• high-pressure water cleaner;
• high-pressure delivery pipe with fast coupling;
• Lance with nozzle
• Lance with rotating nozzle
• use and maintenance manual;
• nozzle cleaning pin;
• handlebar;
• 2 screws to secure handle,
In case of problems, apply to the dealer or to an authorised service centre.
3.3 o
ptIonal
a
ccessorIes
The standard accessories for the high pressure cleaner can be integrated with the following vast range
of accessories:
• Sandblasting lance: designed for smoothing down surfaces, eliminating rust, paint, deposits etc.
• Pipe-draining probe: designed for unblocking pipes and ducts.
• Rotating water jet brush: designed for cleaning delicate surfaces.
• floor cleaning lance.
WARNING
• The operation of the water cleaner may be impaired if unsuitable accessories are used and they may even
make it dangerous. Only use original accessories endorsed by the Manufacturer.
Refer to the documents provided with the optional accessories for information regarding their general
use, safety warnings, installation and maintenance.
4 I
nstallatIon
4.1 a
ssemblInG the
a
ccessorIes
a) Insert the handling bar (3) onto the body of the high pressure cleaner. Make sure you fully insert
the bar into the high-pressure cleaner’s body (the front surfaces must be aligned with one another).
Secure the bar with the 2 screws supplied (cross head screwdriver not supplied). Step A in fig. 2
b) Unroll the high-pressure hose (23), connect the quick-fit connector (24) to the water outlet
connector (8), screw down and secure. Step C in fig. 3.
c) Screw the end of the high pressure hose (23) (the end without the quick fit connector) onto the thread
of the spray gun (14) and secure it tightly using two 17 mm socket keys (not supplied). Step d in fig. 3.
4.2 c
hecks and
c
onnectIon to the
m
aIns
W
ater
s
upply
CAUTION
• The water supply must be able to guarantee the adequate delivery of water flow to the high pressure
cleaner; refer to the table of technical specifications.
In case of doubt, contact a Skilled Technician.
• Do not supply the water cleaner with water at a temperature in excess of 40°C/98°F or below 5°C/41°F.
• The pressure of the water supply must not be in excess of 8 bar/116 psi.
• Do not operate the high pressure cleaner with a priming depth in excess of 0 m/0 ft.
EN