EMAK PW 146C, Инструкция для оператора

Страница: 11 / 56

11
• Do not point the jet towards oneself or other people in order to clean off clothing or footwear.
• To protect the environment, vehicle engines and machinery with oil-pressure circuits must only be cleaned
in areas with a suitable oil trap.
• Vehicle tyres must be cleaned at a distance of at least 50 cm/19 in to safeguard them from being damaged
by the high-pressure jet. The first evidence of damage to a tyre is a change in colour.
• Do not point the high-pressure jet towards materials, which contain asbestos or other harmful substances.
• Do not use the water cleaner in the rain.
• Pay particular attention to the instructions in the “Checks and connection to the mains electricity
supply” section.
• Pay particular attention to the instructions in the “
Use with detergents
” section.
• When the water cleaner is not in use, do not leave its plug in the power outlet and disconnect it before
any activity. More precisely, make sure that the mains switch (2) is in position “0”, remove the plug from
the power outlet, press the lever (26) on the cleaner gun to eliminate any remaining pressure and bring
the safety catch in its locked position (25) (Fig. 4 - position S):
- before leaving the high power cleaner unattended, even for only a short time;
-
after use;
In addition, wait until the high pressure cleaner has completely cooled down before cleaning or
maintenance.
• During use, do not lock the lever (26) on the cleaner gun in the open position.
• Do not remove the plug from the power outlet by pulling on the power supply cable.
• Do not put any reducers or adaptors between the electric plug and the power outlet.
• Keep the power supply cable, any extension cords, the plugs and the outlets dry. Do not touch them with wet hands.
• If the supply cord is damaged, it must be replaced by the Manufacturer or by a Skilled Technician , in
order to avoid a hazard.
• Do not cover the high pressure cleaner during operation and do not place it where there is inadequate
ventilation.
• When the high pressure cleaner is used in enclosed spaces, make sure that there is adequate ventilation.
5.1 h
andlInG
• When handling the high-pressure cleaner, use the handling bar (3) as shown in Fig. 5 operation M.
• Use the lifting handle (10) for lifting Fig. 5 operation N.
WARNING
• Do not use the handling bar (3) to lift up the high-pressure cleaner.
5.2 p
relImInary
p
rocedures
• Unroll the high-pressure pipe (23) completely.
• Attach a supply pipe to the water inlet’s quick connection (12) using a normal garden connector. Step
e - fig. 3.
• Open the tap to the water supply and make sure that there are no drips. Step f - fig. 3.
• Make sure that the main switch (2) is in the off position (the “0” position) and put the plug into the
electric current outlet. Step G - fig. 3.
• Push the main switch (2) to position “1”.
• Press the cleaner gun’s control lever (26) and wait for a continuous jet of water to be issued.
• Put the main switch (2) to position “0” and connect up the lance hose (11) and the spray gun (14),
securing it tightly. Step b in fig. 3.
5.3 s
tandard
o
peratIon
(
hIGh pressure
)
• Restart the high pressure cleaner by turning the main switch (2) to position “1”.
Note: during this restart phase, the high pressure cleaner will immediately stop operating after the
initial peak, as the Total Stop device will take effect.
• Use the cleaner gun’s lever (26) to start operation of the high pressure cleaner and thus start cleaning.
• You can alter the angle of the jet by adjusting the head (27) (Fig. 4 - Positions a and b).
EN