EMAK PW 146C, Инструкция для оператора

Страница: 12 / 56

12
5.4 u
se WIth
d
eterGents
WARNING
• The high pressure cleaner was designed to be used with the detergents recommended by the Manufacturer.
Use of other detergents or chemicals can affect the safety of the high pressure cleaner.
Never suck up liquids, which contain solvents, petrol, diluents, acetone and fuel oil, as these products are
highly inflammable, explosive and toxic when nebulized.
• Carefully read the instructions and warnings on the label of the detergent to be used.
• Store detergents in a safe place out of children’s reach.
• Should detergent come into contact with your eyes, wash immediately with water. Contact a doctor
without delay and remember to take the container of detergent with you.
• If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and remember to
take the container of detergent with you.
The recommended detergents, are over 90% biodegradable.
For information on how to use the detergents, refer to the instructions in the table below and on the
label on the container of detergent.
• Fill the bottle (21) with the desired detergent
• Regulate the detergent suction capacity in the following way:
- disconnect the rod (20) from the lance (19);
- the L tooth on the rod (20) must match with one of the numbers on the inside of the lance (19) (1:
minimum suction, 6: maximum suction);
- re-connect the rod (20) in the lance (19).
• Insert the bottle (21) in the foam lance (19).
• Put the main switch (2) to position “0” and connect up the lance (19) and the spray gun (14).
• Start up the high pressure again, by putting the main switch (2) to position “1” and operating its lever
(26) (suction and mixing will start automatically when water goes through).
5.5 I
nterruptInG
u
se
(
total stop
)
Release the lever (26) on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed again.
WARNING
• It is important to remember that the high pressure cleaner is still operational when it is in Total Stop
mode. Therefore, always put the main switch (2) in position “0”, remove the plug from the power outlet,
press the lever (26) on the cleaner gun to eliminate any remaining pressure and lock the safety protection
device (25) (Fig. 4 - position S), before leaving it unattended, even for a short time.
6 s
WItchInG
o
ff and
s
toraGe
After cleaning, switch the water cleaner off and prepare it for storage.
6.1 s
WItchInG
o
ff
• Close the tap for the water supply securely.
• Empty the water out of the water cleaner by pressing the lever (26) on the cleaner gun for a few
seconds.
• Put the main switch (2) in position “0”
• Remove the plug from the power outlet.
• Press the lever (26) on the cleaner gun to eliminate any remaining pressure in the high-pressure pipe
(23).
• Rewind the power supply cable (1) with care and hook it to its support (13).
• Wait for the high pressure cleaner to cool down.
WARNING
• When the water cleaner is left to cool down, take care that:
- the water cleaner is not left unattended in the presence of unsupervised children, elderly or disabled
people.
- the water cleaner is in a stable position and not at risk of falling over.