ELTEX ESR Series, Руководство пользователя

Страница: 245 / 575

ESR-Series. User manual
245
esr(config-ospf)# area 1.1 . 1.1
esr(config-ospf-area)# enable
esr(config-ospf-area)# exit
Enable advertising of the routing information from RIP:
esr(config-ospf)# redistribute rip
Enable OSFP process:
esr(config-ospf)# enable
esr(config-ospf)# exit
Neighbouring routers are connected to gi1/0/5 and gi1/0/15 interfaces. To establish the neighbouring with
other routers, map them to OSPF process and the area. Next, enable OSPF routing for the interface.
esr(config)# interface gigabitethernet 1 / 0 / 5
esr(config- if -gi)# ip ospf instance 10
esr(config- if -gi)# ip ospf area 1.1 . 1.1
esr(config- if -gi)# ip ospf
esr(config- if -gi)# exit
esr(config)# interface gigabitethernet 1 / 0 / 15
esr(config- if -gi)# ip ospf instance 10
esr(config- if -gi)# ip ospf area 1.1 . 1.1
esr(config- if -gi)# ip ospf
esr(config- if -gi)# exit
esr(config)# exit
11.4.3 OSPF stub area configuration example
Objective:
Change 1.1.1.1 area type, area should be stub. Stub router should advertise routes received via RIP.
Solution:
Pre-configure OSPF protocol and IP addresses on interfaces according to the network structure shown in
figure .
Change area type to stub. For each router from 1.1.1.1 area, execute the following command in the
configuration mode:
esr(config-ospf-area)# area-type stub