Elsner KNX VOC-UP basic, Инструкция по установке и настройке

Страница: 6 / 28

4 Description
Mixed Gas Sensor KNX VOC-UP basic • Version: 27.01.2020 • Technical changes reserved. Errors reserved.
1.1. Technical specifications
The product conforms with the provisions of EU directives.
1.1.1. Accuracy of the measurement
Measurement variations from sources of interference (see chapter Installation
position ) must be corrected in the ETS in order to ensure the specified accuracy of the
sensor (offset). To ensure a correct VOC measurement, the device must be installed in
a windproof socket.
The indicated accuracy of the VOC measurement will be achieved after a room air
exchange (without interruption of the bus voltage) if the sensor has been in contact
with fresh air at least once in this period. After this, the sensor will recalibrate itself at
regular intervals.
To guarantee the accuracy on a sustained basis, the sensor should be provided with
fresh air at least once in 48 hours. This occurs normally during room ventilation.
1.1.2. Measuring ranges of different gases (CO2 equivalents)
Corresponding VOC concentrations for specific representatives
Housing Plastic material (partly lacquered)
Colours • White glossy (similar to RAL 9016 Traffic White)
• Special colours on request
Mounting
In-wall (in socket
Ø 60 mm, 42 mm deep)
Protection category IP 20
Dimensions Housing approx. 55 x 55 (W x H, mm),
mounting depth approx. 15 mm,
base plate approx. 71 x 71 (W x H, mm)
Total weight approx. 55 g
Ambient temperature Operation 0…+50°C, storage -20…+50°C
Ambient air humidity avoid bedewing
Operating voltage KNX bus voltage
Bus current max. 10 mA; max. 500 mW
Data output KNX +/- bus terminal plug
BCU type Own micro controller
PEI type 0
Group addresses max. 254
Allocations max. 254
Communication objects 133
Measurement range 450...2000 ppm
Resolution 1 ppm