23
Parameter setting
GPS Receiver Vari KNX GPS
• Status: 22.08.2017 • Errors excepted. Subject to technical changes.
6.5.
Weekly timer
The weekly timer in the device allows for 24 periods to be defined.
The respective period objects can be configured as inputs or outputs, i.e. send to the
bus (internal timer function, use internal and for other bus members) or be switched
from there (timer function via an external device). If several devices are used in the sys-
tem, the timer settings may be done on one device that sends the period objects as out-
put. The other devices apply the timer-command (input), whereby a better synchroni-
sation is achieved.
Activate the required periods for the weekly timer. The menus for setting the timer are
loaded.
6.5.1. Weekly timer period 1-24
Set whether the period can be set (period object is the output and is sent to the bus) or
if the period is received externally via the bus (period object is the input).
Period can be set (time period object is output)
Set whether the switching times are set per object and in which cases the switching
times received are to be retained. Please note that the setting "After power restoration
and programming" should not be used for the initial start-up, as the factory settings are
always used until the first call (setting via objects is ignored).
on change of
(if sent on change)
0.1 degrees • 0.2 degrees • 0.5 degrees •
1.0 degree • 2.0 degrees • 5.0 degrees
Send cycle
(if sent periodically)
5 s ... 2 h; 1 min
Use period 1/2/3/.../24
No • Yes
Period
• can be set
(period object is output)
• can be switched (time period object
is output)
Use objects for switching times
No • Yes
The threshold values and delays received by the communication object
Switching data should
• not be retained
• be retained after power restoration
• be retained after power restoration and
programming
