19
Parameter setting
GPS Receiver Vari KNX GPS
• Status: 22.08.2017 • Errors excepted. Subject to technical changes.
6.
Parameter setting
6.1.
Behaviour on power failure/ restoration of
power
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block.
6.1.1. Malfunction objects
Malfunction objects are sent after every reset and, additionally, after changes (i.e. at
the beginning and end of a malfunction).
6.1.2. General settings
Set basic characteristics of data transfer. A different transmission delay prevents an
overload of the bus shortly after the reset.
Set the function of the signal LED. Via the input objects "Signal LED object 1s/4s cycle",
the LED can visualise two different types of information flashing slowly or quickly. If
both objects receive a 1, it flashes in the prioritised cycle.
6.2.
GPS
Set whether the time and date are to be sent as separate objects or as one common
object. Specify whether the time and date are to be set by the GPS signal or objects.
If time and date are
set by the GPS-Signal
, the data is available as soon as a valid
GPS signal is received.
If time and date are
set by two objects
, then only a maximum of 10 seconds may
elapse between receiving the date and receiving the time Furthermore, a change of
Transmission delay after reset/restoration of bus for:
GPS and sun position objects
5 … 300 seconds
Time switch objects
5 … 300 seconds
Maximum telegram quota
1 • 2 • 5 • 10 • 20 • 50 Telegrams per sec.
Function of the signal LED
• always OFF
• flashes if a signal LED object
receives a 1
The following has priority
(if the signal LED is being used)
• Signal LED object 1s cycle
• Signal LED object 4s cycle
