9
Addressing the device
GPS Receiver Vari KNX GPS
• Status: 22.08.2017 • Errors excepted. Subject to technical changes.
2.4.3. Connection
The connector is in the lower part of the housing.
2.4.4. Completing the installation
3.
Addressing the device
The device is delivered ex works with the bus address 15.15.250. You can program a
different address in the ETS by overwriting the address 15.15.250 or by teaching the
device via the programming button.
Fig. 10
Break the cable guide off.
Feed the power lead through the rubber gas-
ket.
Rubber
gasket
Cable guide
Fig. 11
Connect the device to the KNX bus via
the pluggable terminal (+|-).
-
+
-
+
KN
X
Fig. 12
Put the cover on the lower part. This also
makes the plug-in connection between the
board in the cover and the socket in the lower
part.
