ELRO PRECIJET+ EPJ061E, Руководство по установке

Страница: 26 / 41

3E-490044NI – 03/20 Page 2
EN
ELRO-Werke AG
Wohlerstrasse 47
5620 Bremgarten
GENERAL REQUIREMENTS
WARRANTY
To ensure the guarantee on this equipment, you should comply with the MANUFACTURER’S INSTRUCTIONS in this manual.
However if you cannot undertake the required maintenance operations, our installation and service network is available to provide you with a
personalized contract.
WARNING
- The product delivered to you complies with current standards. If any modifications are made the manufacturer cannot accept any
responsibility whatsoever. The manufacturer cannot be held responsible in the event of inappropriate use of the equipment.
- This equipment is intended for use by suitably trained professionals.
- When handling it, it is imperative to leave the appliance on its base till final installation.
- Read all the documentation before installation.
- Keep your documents for future reference.
- Translation of the original manual
A qualified engineer must carry out the installation, modification or repair of the appliance in a workmanlike manner.
These appliances must be installed with sufficient ventilation to prevent the formation of excessive concentrations of noxious substances
hazardous to health in the area in which they are installed.
The appliance is of Type A (not connected to an exhaust duct for combustion products).
The required flowrate of new air for combustion is 2 m3/h per kW of heat release rate.
If these units are installed against a wall or a partition, this must be of non-combustible materials or, if not, it must be covered with an
appropriate, good insulating and non-combustible material.
Observe the necessary minimum distances between the appliance and a partition (wall or other cooking appliances) (4cm on left, 50cm on
right).
Do not place a source of heat against the right hand side of 6 and 10 level ovens.
Unless specified otherwise, the parts protected by the manufacturer or his authorized representative must not be handled by the installer.
The manufacturer certifies that the packaging meets the provision 94/62/CE (relating to packaging and packaging waste of 20.12.94) and
requests that the final installer (or user) observes the rules relating to the removal of the packaging (recycling or reuse).
Always comply with current local regulations regarding connecting the unit to water, electricity and drainage.
ATTENTION – Disconnect electrically before any form of maintenance.
Never use descaling product in the automatic cleaning system. This could seriously damage the ovens hydraulic circuits.
In order to ensure optimum cleaning results without the risk of chemical attack we recommend using our cleaning chemical BK101. Other
products can be used. Generally cleaning products that are compatible with our ovens should:
- have a composition based on potassium hydroxide with a concentration < 25%, WITHOUT sodium hydroxide
- be suitable for use at a temperature of 60°C.
- include anticorrosion agents
Danger of irritation to the skin and eyes or acid burns.
Detergents and descalers will cause irritation and possible burns if in direct contact with the skin or eyes.
- Do not inhale the mist or spray
- Avoid direct contact with these products
- Never open the oven door during the automatic cleaning cycle
- Wear protective clothing, gloves and hermetic protective goggles in accordance with the safety data sheet.
Remember the dangers identified on the safety data sheet for each detergent or descaler
- Harmful if swallowed.
- Can result in serious burns.
- Irritates the eyes.
- Irritates the respiratory tracts.
- Risk of serious eye lesions.
Remember the safety advice provided by the safety data sheet for each detergent or descaler
- Do not each or drink when using these products.
- Do not inhale their vapours.
- If case of contact with eyes rinse immediately with plenty of water and seek medical advice.
- Wear appropriate protective clothing, gloves and face and eye protective gear.
- In the event of an accident or sickness seek immediate medical attention
- Dispose of the product and its container as hazardous waste.
The manufacturer disclaims any liability in the event that the above instructions are not followed.
The appliance should only be handled with suitable lifting equipment. Should the appliance need to be transported, this must be on its original
pallet and it must not be stacked on other appliances under any circumstances. If the appliance is to be moved without its pallet, it should be
carried and not pulled. Fig. 1.1A, 1.2A-B-C, 1.3A-B-C-D.