Gold Solo Double Twitter Installation Guide
MAN-G-SOLTWIB_160 (Ver. 1.005)
|
Main, Control, and Motor Power|
www.elmomc.com
31
Table of Contents
8.1.4.2.
Control Supply (J10)
Connect the VL+ and VL- pins on the Gold Solo Double Twitter in the manner described in the table
and drawing below.
Pin Signal Function
Pin Positions
30 VL+
Control Supply Input
29 VL-
Control Supply
Return
1.
Standard CAN (S option)
Input range: 11VDC – 95VDC
Power consumption: < 2.5W
(including 5 V/200 mA for
encoder)
2.
EtherCAT (E option)
Input range: 11VDC – 95VDC
Power consumption: < 4W
(including 5 V/200 mA for
encoder)
Table 4: Control Supply Pins
Connect the VL+ and VL- terminals to the
power supply
Control Connector.
To connect the VL+ and VL- to the control supply:
1.
The source of the control supply must be isolated from the Mains.
2.
Connect the return (common) of the control supply source to the closest earth connection
near the control supply source.
3.
Connect the VL+ and VL- wires to the terminals on the servo-drive as shown in Figure 11.
Figure 11: Connecting the Control Supply Wires
For short distances between the drive and control, 0.5 to 1.0 m wires can be used and
shielding is not required.
For longer distances than 1.0 m and/or high EMI environment,
shielded and twisted wires should be used. Drain wires should be connected to Elmo COMRET.
4.
Before applying power, first verify the polarity of the connection.
