Gold Solo Double Twitter Installation Guide
MAN-G-SOLTWIB_160 (Ver. 1.005)
|
Wiring the Female Connectors|
www.elmomc.com
25
Table of Contents
7.5.
Wiring the Female Connectors
Figure 6: Inserting a wire/pin to the Female Connector
To insert a wire/pin to the female connectors of J10, J11, J17, and J18 do the following:
1.
Select the relevantly colored wire to insert to a specific rectangular compartment on the
female connector.
2.
Use the appropriate Molex crimping plier (Molex P/N 63819-1500) to fasten a pin connector
to the end of the wire.
3.
Place the connector on a flat surface, in the orientation as shown in Figure 6.
Notice that the rectangular slot has a niche at the bottom of the slot.
4.
Insert the wire connector to the slot as shown in Figure 6. Make sure that the connector
protrusion is inserted to the bottom of the rectangular slot.
When inserting the wire connector to a slot in the second row, make sure to rotate the
connector in the opposite orientation.
5.
Repeat the same procedure for any other wire connections.
