Mitterweg 25 – Via di Mezzo ai Piani 25
I
-39100 Bozen
-
Bolzano
Tel.:0471 977236
-
Fax:976525
e-mail:
http://www.elmed.it
3
Safety information
WARNING! The following safety information aims to preserve the personal safety of the
user and protect the equipment and working environment from possible damage.
General
•
Do not attempt to repair the device yourself if you have not received appropriate training.
Always fully comply with all installation instructions.
•
Improper use of or interference with the device may result in damage to the device, fire or
other hazards. In addition, guarantee and warranty claims will be invalidated.
•
Do not insert any objects in component apertures. This may damage the device by short-
circuiting the internal components.
•
The device is protected against condensation and atmospheric moisture by a protective
lacquer. Nevertheless, deterioration of the lacquer may cause the device to be damaged due
to condensation. For this reason, if you enter a room with strongly fluctuating temperatures or
atmospheric humidity, please wait until the moisture has evaporated before starting up the
device.
Power supply
•
Ensure that the polarity is correct before starting up the device.
The correct polarity for the connecting wires is shown in the wiring
diagram.
•
Check the operating voltage! When the motor is running and all of
the nozzle rings are switched on, the operating voltage must be over 13V. It is possible to
display the voltage in the display area (
chapter 1.1).
•
Protect the connecting wires: do not use the lead for pulling out the plug or carrying the
device. Make sure that the connecting wires do not come into contact with heat or sharp edges.
Damaged connecting wires may cause fire, short circuits and electric shocks.
Cleaning
•
Do not use chemical solvents for cleaning, as these may damage the
plastic surface. You should also not use a pressure washer for cleaning. Any
water penetration could result in damage to the device.
•
Clean the display with a soft, clean cloth and water. Moisten the cloth with
water and wipe the screen evenly in one direction from top to bottom. Quickly
remove any remaining moisture from the display and keep it dry. Over the long
term, moisture may damage the display. Do not use conventional window
cleaner for cleaning the display.
Assembly
•
The SPG20 control unit that is fitted to the tank must be fitted in such a way that the cable
grommets point downwards to make it harder for water to penetrate.